Ht Physical Mode Settings; Figure 35: Ht Physical Mode Settings - Alfa Network AIP-W502 User Manual

The HT Physical Mode section on the Wireless Settings Advanced page
HT P M
HYSICAL ODE
includes additional parameters for 802.11n operation.
S
ETTINGS

Figure 35: HT Physical Mode Settings

The following items are displayed in this section on this page:
◆
◆
◆
◆
◆
HT Channel Bandwidth — The Mini Broadband Router provides a
channel bandwidth of 40 MHz by default giving an 802.11g connection
speed of 108 Mbps (sometimes referred to as Turbo Mode) and a
802.11n connection speed of up to 150 Mbps. Setting the HT Channel
Bandwidth to 20 MHz slows connection speed for 802.11g and 802.11n
to 54 Mbps and 74 Mbps respectively and ensures backward compliance
for slower 802.11b devices. (Default: 20MHz)
Guard Interval — The guard interval between symbols helps receivers
overcome the effects of multipath delays. When you add a guard time,
the back portion of useful signal time is copied and appended to the
front. (Default: Auto)
MCS — The Modulation and Coding Scheme (MCS) is a value that
determines the modulation, coding and number of spatial channels.
(Options: value [range] = 0~7 (1 Tx Stream), 8~15 (2 TxStream), 32
and auto (33). Default: auto)
Reverse Direction Grant (RDG) — When Reverse Direction Grant is
enabled, the Mini Broadband Router can reduce the transmitted data
packet collision by using the reverse direction protocol. During TXOP
(Transmission Opportunity) period, the receiver could use remaining
transmission time to transmit data to a sender. The RDG improves
transmission performance and scalability in a wireless environment.
Extension Channel — When 20/40MHz channel bandwidth has been
set, the extension channel option will be enabled. The extension
channel will allow you to get extra bandwidth. (Options: 2417MHz/
Channel 2, 2457MHz/Channel 10. Default: AutoSelect.)
– 67 –
| Wireless Configuration
C 7
HAPTER
Basic Settings