Setting The Pressure Regulator - Fisher & Paykel OR36SDPWGX Installation Instructions Manual

CONVERSION TO LP/PROPANE GAS (OR CONVERSION BACK TO THE ORIGINAL GAS - NA-
TURAL GAS)
Every range is provided with a set of orifi ces for the various types of gas.
Select the orifi ces to be replaced according to the "ORIFICES TABLE".
The nozzle diameters, expressed in hundredths of a millimetre, are marked on the body of each orifi ce.
CAUTION: Save the orifi ces removed from the appliance for future use.

SETTING THE PRESSURE REGULATOR

The pressure regulator is accessible by removing the warmer drawer; the pressure regulator is positioned on the rear right side of the
range (fi g. 2.9).
To remove the warming drawer:
1. Open the drawer completely (fi g. 2.8)
2. Move down the lever of left guide (fi g. 2.8a) and up the lever of right guide (fi g. 2.8b).
3. Remove the drawer holding the levers in the same position (fi g. 2.8).
Fig. 2.8a
WARNING:
• Do not remove drawer while
hot.
• Do not remove drawer du-
ring operation.
• Be sure drawer is empty be-
fore removing.
• Always position your hand
below the front panel to
open/close the drawer.
Fig. 2.8b
Fig. 2.8
2
17 17