Self-Diagnosis By Remote Control (Check Code) - Toshiba RAS-07SKHP-E Service Manual

9-4. Self-Diagnosis by Remote Controller (Check Code)
1. If the lamps are indicated as shown B to G in Table 9-3-1, exchanger the self-diagnosis by the remote control.
2. When the remote controller is set to the service mode, the indoor controller diagnoses the operation condi-
tion and indicates the information of the self-diagnosis on the display of the remote control with the check
codes. If a fault is detected, all lamps on the indoor unit will flash at 5Hz and it will beep for 10 seconds
(Pi, Pi, Pi.... ). The timer lamp usually blinks (5Hz) during self-diagnosis.
9-4-1. How to Use Remote Controller in Service Mode
TOSHIBA
P R E S E T F A N
T E MP
TEMP
ONE -T OUC H MODE
C OMF OR T
QUIE T S L E E P
S WING F IX Hi-P OWE R E C O
T IME R C L R
ON OF F
S L E E P S E T
C HK F IL T E R C L OC K
Alphanumeric characters are
used for the check codes.
is 5.
is A.
is C.
1
2
3
is 6.
4
is B.
is D.
Press [CHECK] button with a tip of pencil to set the
remote controller to the service mode.
• " " is indicated on the display of the remote
controller.
Press [ON ] or [OFF
If there is no fault with a code, the indoor unit will beep
once (Beep) and the display of the remote controller will
change as follows :
• The TIMER indicator of the indoor unit flashes continuously.
(5 times per 1 sec.)
• Check the unit with all 52 check codes (
as shown in Table-11-4-1.
• Press [ON ] or [OFF
code backward.
If there is a fault, the indoor unit will beep for 10
seconds (Beep, Beep, Beep...).
Note the check code on the display of the remote
controller.
• 2-digits alphanumeric will be indicated on the display.
• All indicators on the indoor unit will flash.
(5 times per 1 sec.)
Press [ ] button to release the service mode.
• The display of the remote controller returns to as it
was before service mode was engaged.
Time shortening method.
1. Press SET button while pushing CHECK button.
2. Press [ ] button.
Fig. 11-4-1
− 47 −
FILE NO. SVM-07023-1
] button
• • •
to
] button to change the check
)