Brinkmann 3820 Owner's Manual page 34

Step 19
Loosen the two bolts with washers from
the bottom of the burner assembly
bracket. This will allow the burner to
move freely while performing Step 20.
Step 20
Remove two M4 bolts and washers
from the side burner valve. Insert the
side burner valve assembly through
the hole in the side burner front
panel, seat the valve nozzle into the
burner venturi. Hold in place while
you perform Step 21.
WARNING: Never use your grill without
leak testing all gas
connections and hoses. See
the section on "Leak Testing"
in this manual for proper
procedures.
Step 21
Place the bezel over the control knob
mounting stem and position over holes
in side burner base and side burner
valve assembly. Attach with two
M4 X 10 mm bolts with washers which
come with valve. Install the side burner
control knob onto valve stem. Tighten
up the burner assembly / bracket
bolts loosened in Step 19.
Step 22
Attach side burner igniter lead wire to
the electrode as illustrated.
33
Bezel
Control Knob
Electrode
Igniter Lead