Table of Contents
Advertisement
13.AC Inlet
After the correct voltage has been set you can connect the AC plug to the unit and in the AC power socket.
14.Input Connectors
Both XLR and 1/4" TRS jack input connectors are supplied in your
15.Output Connector
Both XLR and 1/4" TRS jack output connectors are supplied in your
4. INSTALLATION & CONNECTION
4.1 Mains Connection
A Main AC cable that meets all the international safety regulations is supplied with your
sure of the supply voltage available in your Country before plugging in the power cord into the AC socket.
4.2 Audio Connection
Both XLR and 1/4" TRS connectors are available on your
several different ways without experiencing any noise or signal loss. You can use your
using the mixers main insert or on the complete mix connecting the
lifier.
- Wiring Configuration
Either the 1/4" TRS phone jack or the XLR connector can be wired in balanced and unbalanced modes, which will
be determined by the actual application status, please wire your system as the following wiring examples:
For 1/4" Phone jack
TS Type Unbalanced
For XLR connector
XLR Type Unbalanced
- In Line Connection
For these applications the 5-Band Parametric Equalizer provides 1/4" TRS connectors and XLR connectors to
easily interface with most any professional audio device. Follow the configuration examples below for your parti-
cular connection.
+
Tip
Sleeve
Pin2 (+)
Pin3 (-)
(Linked to Pin1 manually,
Pin1 ( )
LTO
LTO
LTO
-Q. In this way you can interface your
LTO
-Q in between the mixer and the power amp-
+
-
Tip
Ring
Sleeve
TRS Type Balanced
Pin3 (-)
)
6
-Q for maximum flexibility.
-Q for maximum flexibility.
LTO
-Q. Please make
LTO
-Q with single instruments
Tip
Ring
Sleeve
TRS Type Unbalanced
Pin2 (+)
Pin1 ( )
XLR Type alanced
B
LTO
-Q in
+
Advertisement
Table of Contents
