Trunk Information; Vlan Information - HP nj2000 User Manual

Trunk Information

This table will be empty if no trunks have been configured from the TRUNKS >
page. The table has four columns as follows:
Trunk - The Trunk Label. T1 through T4 may appear in this column.
Type - All trunks and ports on this switch are 10/100/1000M
Trunk Status - An indication of the speed and duplex setting of the trunk. This is a
number, the speed in Mbps, followed by either Full for full-duplex or Half for half-duplex.
This can be changed on the TRUNKS > Settings page.
Ports - The ports that are members of the trunk.

VLAN Information

VLANs can be added on the VLANS > VLAN Setup page. The two columns in this table are used
as follows:
VLAN ID - A number in the range 1 - 4094 which identifies the VLAN.
VLAN Members - A list of the ports that are members of the VLAN. By default, all ports
are members of VLAN 1.
Copyright © 2009 3Com Corporation. All Rights Reserved.
3Com Network Jack NJ2000
Membership
Page 6 of 44