Skoda Superb B8 Owner's Manual page 230

Fig. 246 Principle sketch: Attach lifting jack
The procedure for lifting the vehicle is valid for all body versions.
Use the jack from the tool kit to raise the vehicle.
Position the car jack at the jacking point closest to the flat tyre .
The mounting points are located on the metal bar
›
Insert the crank into the mount on the jack
6
›
Support the base plate of the jack with its full area resting on level ground
and ensure that the jack is located in a vertical position at the jacking point
» Fig. 246 - .
›
Position the lifting jack below the jacking point with the crank and move it up
until its claw encloses the web
›
Continue turning up the jack until the wheel is just about lifted off the
ground.
WARNING
If the wheel has to be changed on a slope, first of all block the opposite
■
wheel with a stone or similar object to prevent the vehicle from unexpect-
edly rolling away.
Secure the base plate of the lifting jack with suitable means to prevent
■
possible moving. A soft and slippery ground under the base plate may move
the lifting jack, causing the vehicle to fall down. It is therefore always nec-
essary to place the lifting jack on a solid surface or use a wide and stable
base. Use a non-slip base (e.g. a rubber foot mat) if the surface is smooth,
such as cobbled stones, tiled floor, etc.
Only attach the lifting jack to the attachment points provided for this pur-
■
pose.
Always raise the vehicle with the doors closed.
■
» Fig. 245.
» page 223.
5
» Fig. 246 - .
WARNING (Continued)
Never position any body parts, such as arms or legs under the vehicle,
■
while the vehicle is raised with a lifting jack.
When the vehicle is raised, never start the engine.
■
CAUTION
It is important to ensure that the jack is correctly attached to the web of the
lower fork leg - risk of damage to the vehicle.
Remove the wheel / fix
When changing a wheel, the following instructions must be followed.
›
Remove the full wheel trim or the caps of the wheel bolts.
›
First of all slacken the anti-theft wheel bolt and then the other wheel bolts.
›
Jack up the vehicle until the wheel that needs changing is clear of the
ground.
›
Unscrew the wheel bolts and place them on a clean surface (cloth, paper,
etc.).
›
Remove the wheel carefully.
›
Attach the wheel and slightly screw on the wheel bolts.
›
Lower the vehicle.
›
Tighten the wheel bolts opposite each other using the wheel wrench (alter-
nating crosswise). Tighten the anti-theft wheel bolt last.
›
Replace the wheel trim or the caps.
When fitting unidirectional tyres, ensure that the direction of rotation is cor-
rect » page 219.
All bolts must be clean and must turn easily.
If it is established when changing a wheel that the wheel bolts are corroded
and difficult to move, then these must be replaced.
Under no circumstances grease or oil the wheel bolts!
WARNING
Undo the wheel bolts only a little (about one turn) as long as the vehicle
has not yet been jacked up. Otherwise the wheel could become loose and
fall off.
Emergency equipment and self-help
227