Adjusting The Idle Speed - KTM 60 SX Owner's Handbook Manual

4

Adjusting the idle speed *

The idle speed can be adjusted with screw
1
Turn the screw clockwise to increase the idle speed.
Turn the screw counterclockwise to reduce the idle speed.
Checking the gear oil level
An inspection glass
the gear oil level.
– Warm up the engine, then turn it off and wait two minutes until the oil
has flown back into the gearbox case.
– Park the motorcycle straight on a horizontal surface and check the oil
level.
2
– The oil level must not drop below the "MIN" mark of the inspection
glass.
Note: If the motorcycle is not parked properly for the oil level inspection
it will not be possible to achieve a reliable result.
– If necessary add engine oil (10W40 (e.g. Shell Advance Ultra 4).
N
OT ENOUGH OIL OR A POOR OIL QUALITY LEAD TO PREMATURE WEAR OF THE TRANS
. T
MISSION HEREFORE
Changing the gear oil *
Before changing the gear oil warm up the engine and park the motorcycle
3
on a horizontal surface. Remove the oil drain plug
into an appropriate container. Clean the sealing surface. Mount the oil drain
plug together with its gasket and tighten with 15 Nm (11 ft.lb).
Remove the filler plug
Advance Ultra 4). Mount the filler plug and check the engine for leaks.
N
OT ENOUGH OIL OR A POOR OIL QUALITY LEAD TO PREMATURE WEAR OF THE TRANS
. T
MISSION HEREFORE
2
on the left side of the engine allows easy checking of
CAUTION
!
, -
USE ONLY HIGH QUALITY OILS
4
and add 0.30 l engine oil 10W40 (e.g. Shell
CAUTION
!
, -
USE ONLY HIGH QUALITY OILS
1
.
!
( . . S A U
E G HELL DVANCE LTRA
3
and drain the used oil
!
( . . S A U
E G HELL DVANCE LTRA
19
-
4).
-
4).