Symbols On The Product; Replacing Guide Bar And Saw Chain; Inspecting And Cleaning The Chain Brake; Maintenance Schedule - Ryobi RCS36X3550HI Original Instructions Manual

repaired or replaced by an authorized service centre.

REPLACING GUIDE BAR AND SAW CHAIN

See page 21 - 22.
1.
gloves.
2.
3.
chain from unit.
4. To replace the bar with a new one, unscrew the nut of
the chain tension assembly. Mount the chain tension
assembly on to the new bar and tighten the nut.
5.
bar groove.
Attach the bar to the chain saw and loop the chain
7.
8. Adjust the chain tension. Refer to the "Adjusting the
chain tension" section.
WARNING
A dull or improperly sharpened chain can cause
excessive motor speed during cutting which may result
in severe motor damage.
WARNING
Improper chain sharpening increases the potential of
WARNING
Failure to replace or repair a damaged chain can cause
serious injury.
WARNING
The saw chain is very sharp. Always wear protective
gloves when performing maintenance to the chain.

INSPECTING AND CLEANING THE CHAIN BRAKE

See page 24.

MAINTENANCE SCHEDULE

Daily check
Bar lubrication
Chain tension
Chain sharpness
8
Before each use
Before each use and
Before each use, visual
For damaged parts
For loose fasteners
Inspect and clean
Bar
Complete saw
* Hours of operation

SYMBOLS ON THE PRODUCT

Safety alert
Read and understand all instructions
before operating the product, follow all
warnings and safety instructions.
Wear eye, ear and head protection.
using the product.
avoid contact with bar tip.
Do not expose to rain or damp
condition.
Hold and operate the saw properly
with both hands.
Do not operate the saw using only
one hand.
Waste electrical products should not
be disposed of with household waste.
retailer for recycling advice.
The guaranteed sound power pressure
96
The guaranteed sound power level is
107
107 dB
Bar and chain lubricant
Minimum lubricant level
Before each use
Before each use
Before each use
Before each use
After each use
Every 5 hours*