ZyXEL Communications vmg8924-b10a User Manual page 51

Table 7 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued)
LABEL
Sustainable
Cell Rate
Maximum Burst
Size
PPP Information (This is available only when you select PPPoE or PPPoA in the Mode field.)
PPP User Name
PPP Password
PPP Triger Type
Idle Timeout
PPPoE Service
Name
PPPoE
Passthrough
IP Address (This is available only when you select IPv4 Only or IPv6/IPv4 DualStack in the IPv6/IPv4
Mode field.)
Obtain an IP
Address
Automatically
DHCP
option 60/
Vendor ID
DHCP
option 43
Enable
Static IP
Address
IP Address
Subnet
Mask
Gateway IP
Address
VMG8924-B10A User's Guide
DESCRIPTION
The Sustainable Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted. Type the SCR, which must be less than the PCR. Note that system default is 0
cells/sec.
This field is available only when you select Non Realtime VBR or Realtime VBR.
Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at the
peak rate. Type the MBS, which is less than 65535.
This field is available only when you select Non Realtime VBR or Realtime VBR.
Enter the user name exactly as your ISP assigned. If assigned a name in the form
user@domain where domain identifies a service name, then enter both components exactly
as given.
Enter the password associated with the user name above. Select password unmask to
show your entered password in plain text.
Select when to have the Device establish the PPP connection.
Auto Connect - select this to not let the connection time out.
Connect on Demand - select this to automatically bring up the connection when the
Device receives packets destined for the Internet.Manual - select this if you want to
manually trigger the connection up.
This value specifies the time in minutes that elapses before the router automatically
disconnects from the PPPoE server.
This field is not configurable if you select Auto Connect in the PPP Triger Type field.
Enter the name of your PPPoE service here.
This field is available when you select PPPoE encapsulation.
In addition to the Device's built-in PPPoE client, you can enable PPPoE pass through to allow
up to ten hosts on the LAN to use PPPoE client software on their computers to connect to the
ISP via the Device. Each host can have a separate account and a public WAN IP address.
PPPoE pass through is an alternative to NAT for application where NAT is not appropriate.
Disable PPPoE pass through if you do not need to allow hosts on the LAN to use PPPoE client
software on their computers to connect to the ISP.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not fixed;
the ISP assigns you a different one each time you connect to the Internet. Select this if you
have a dynamic IP address.
This field displays when editing an existing WAN interface. Type the class vender ID you
want the Device to add in the DHCP Discovery packets that go to the DHCP server.
This field displays when editing an existing WAN interface. Type the vender specific
information you want the Device to add in the DHCP Offer packets. The information is used,
for example, for configuring an ACS's (Auto Configuration Server) URL.
Select this option If the ISP assigned a fixed IP address.
Enter the static IP address provided by your ISP.
Enter the subnet mask provided by your ISP.
Enter the gateway IP address provided by your ISP.
Chapter 5 Broadband
51