HP C2488A Technical Reference Manual page 145

c
Vendor Unique Status Codes
Error Code
Hex(Dec)
00(0)
01(1)
02(2)
03(3)
04(4)
05(5)
06(6)
07(7)
08(8)
09(9)
OA(10)
OB(ll)
OC(12)
OD(13)
OE(14)
OF(15)
10(16)
11 (17)
12(18)
13(19)
14(20)
15(21 )
16(22)
17(23)
18(24)
19(25)
1A(26)
1B(27)
1C(28)
10(29)
1E(30)
1F(31)
20(32)
21(33)
22(34)
23(35)
24(36)
25(37)
26(38)
thru
29(41)
DRAFT
Table C-1. Vendor Unique DERROR Status Codes
Not an error condition.
Power-On condition.
Reserved.
Description
Timed out waiting for DSP to complete Power On Self-Test.
After power-on, DSP became Command Ready without Finished being asserted.
DSP reported a revision value incompatible with this firmware version.
Power-On DSP RAM test failed.
Parity error on command received.
Reserved.
Reserved.
Received illegal conmland.
Address of Seek command was outside legal address space.
An attempt was made to set an illegal EEPROM address.
Reserved.
Timed out waiting for EEPROM write to complete.
DSP did not spinup after a spinup command was executed.
Timed out waiting for DSP to become ready for a short term command.
Timed out waiting for DSP to become ready for a long term command.
A Seek was attempted when either the spindle was not SPWl up or the servo PLL was not locked.
The DSP did not end up in tracking mode after a Recalibrate command was executed.
BOWlds test of Track Offset command failed.
A fault is still set after clearing Gate Array fault latches.
Retries were exhausted while trying to verify position during a Recalibrate.
The DC bias adaptation failed to null NPES within the maximum iteration limit.
Maximum iteration limit reached during head alignment SPES null.
DSP sync lost during head alignment SPES measurement.
The drive has entered the Head Alignment Needed state.
The drive has entered the Head Alignment Critical state.
The maximum total (AC+DC) head alignment correction limit was exceeded.
Reserved
DSP failed to complete a Read Track Number command in allotted time.
DSP failed to complete a Spin Down command in allotted time.
Reserved.
DSP failed to complete a Spin Up command in allotted time.
DSP failed to complete a Recalibrate command in allotted time.
DSP failed to complete an Introduce Tracking Offset command in allotted time.
DSP failed to complete a Seek command in allotted time.
DSP failed to complete a Measure Alignment Band conunand in allotted time.
Reserved.
Vendor Unique Status Codes C-1
1/18/93 09:58