Table of Contents
Advertisement
< BD Section >
1. Turn the power on and press [EJECT] button on
the remote control unit to put the LCD TV/BD into
BD mode. Then remove the disc.
2. To put the LCD TV/BD into F/W version up mode,
press [9], [8], [7], [6], and [POP MENU] or [MENU/
EXIT] buttons on the remote control unit in that order.
Fig. a appears on the screen.
" ******* " differs depending on the models.
F/W VERSION UP MODE
Now Loading...
(*1)
http://*******
Fig. a
• URL as shown below is displayed in (*1) of Fig. a.
(URL is different depending on the models.)
[LD427SSX]:http://sylvaniaconsumerelectronics.com
[42MD459B/F7]: http://www.magnavox.com
• The current F/W version of the BD is displayed in (*2).
• The current F/W version of the TV is displayed in (*3).
3. Insert the disc for version up into the disc slot.
4. Press [ENTER] or [OK] button to select "1. ALL".
(Fig. b)
" ******* " differs depending on the models.
F/W VERSION UP MODE
Please Select F/W Update Mode
1. ALL
2. FE
3. BE
http://*******
Fig. b
5. The LCD TV/BD enters the F/W version up mode
automatically. Fig. c appears on the screen. Make sure
to insert the proper F/W for the state of this model.
" ******* " differs depending on the models.
F/W VERSION UP MODE
1. ALL
Version: *.***
(*4)
Reading...
http://*******
Fig. c
FIRMWARE RENEWAL MODE
F/W Name: *******
Ver. *.***
(*2)
******_*.*
(*3)
F/W Name: *******
Ver. *.***
EXIT : POWER
******_*.*
F/W Name: *******
Ver. *.***
***********XA1.b20
EXIT : POWER
******_*.*
The appearance shown in (*4) of Fig. c is
described as follows:
No.
Appearance
1
Reading...
See FL
2
Display
6. After programming is finished, the disc will be
ejected automatically.
At this time, no button is available.
7. Remove the disc.
8. Unplug the AC cord from the AC outlet. Then plug
it again.
9. Press [EJECT] button on the remote control unit to
put the LCD TV/BD into BD mode again.
10. Press [1], [2], [3], [4], and [INFO] buttons on the
remote control unit in that order.
Fig. d appears on the screen.
" ******* " differs depending on the models.
Version Info
F/W Name
Version
Region
EEPROM CLEAR <STOP>
11. Press [STOP] button on the remote control unit.
Fig. e appears on the screen.
" ******* " differs depending on the models.
Version Info
F/W Name
Version
Region
EEPROM CLEAR : OK
EEPROM CLEAR <STOP>
When "OK" appears on the screen, the factory
default will be set. Then the firmware renewal
mode is complete.
12. Press [POWER] button to turn the power off.
Note: The name of buttons may vary with the brand
of unit.
8-1
State
Sending files into the memory
Erasing previous version data
and writing new version data.
:
*******
:
*.***
:
A-1
EXIT : POWER
Fig. d
:
*******
:
*.***
:
A-1
EXIT : POWER
Fig. e
FL9.5FW
Advertisement
Table of Contents
