Service Mode Access - Hitachi 42EDT41A Service Manual

5. SERVICE MODE ACCESS

BURN-IN MODE
BURN-IN MODE
When the Burn-in feature is turned ON, the plasma panel operates normally on all inputs that
have a signal. On inputs that do not have a signal, the plasma panel displays a cycling single
color test pattern (see below) which is generated internally. This can be helpful to determine
if the panel is capable of displaying anything.
Rear Label
1. SUB POWER
2. VOL
2. ADJ
3. VOL
3. ADJ
4. PROGRAM
4. SELECT
5. PROGRAM
5. SELECT
6. INPUT SELECT
6. OK
7. MENU
BURN-IN MODE (ON)
With unit in standby mode
(turned off), press and hold: >
BURN-IN MODE (OFF)
With unit in standby mode
(turned off), press and hold: >
White Yellow
- +
1 2
NOTE:
1st number indicates normal button operation
2nd number indicates function during MENU
1 2 6
1 2
Cyan Green Magenta
7
28
CMP420V1 / CMP420V2 / 42EDT41 (PW1A)
3 4 5
After the unit comes on, continue to hold the
buttons down until the initial OSD goes
away. OSD will then appear indicating that
BURN-IN MODE is engaged.
(OSD > Burn In On)
After the unit comes on, continue to hold the
buttons down until the initial OSD goes
away. OSD will then appear indicating that
BURN-IN MODE is disengaged.
(OSD > Burn In Off)
Red Blue
PW1A
OK
6 7
Black