Radio Tuning Setup; Initial Test Equipment Control Settings - Motorola RADIUS CM200 Basic Service Manual

4-4
7.0

Radio Tuning Setup

A personal computer (PC), Windows 95/98/NT and a tuner program are required to tune the radio.
To perform the tuning procedures, the radio must be connected to the PC, radio interface box (RIB),
and test equipment setup as shown in Figure 4-6.
ELM Adapter
cable FKN8113
ACC
DC
RF
Figure 4-6 Radio Tuning Test Equipment Setup with External RIB
7.1

Initial Test Equipment Control Settings

The initial test equipment control settings are listed in Table 4-2.
Monitor Mode: Power Monitor
RF Attenuation: -70
AM, CW, FM: FM
Oscilloscope Source: Mod
Oscilloscope Horizontal: 10mSec/Div
Oscilloscope Vertical: 2.5 kHz/Div
Oscilloscope Trigger: Auto
Monitor Image: Hi
Monitor BW: Nar
Monitor Squelch: mid CW
Monitor Volume: 1/4 CW
NOTE Refer to Tuner on-line help files for tuning procedures.
Program/
Test Cable
RKN4083
Power
Supply
30 dB Pad
Table 4-2 Initial Equipment Control Settings
Service Monitor
Audio In
Test Box
RLN4460
DB15
RIB
RLN-4008
Cable 3080369B72 (9 PIN)
Cable 3080369B71 (25 PIN)
Transmit
Receive
Test Set
Speaker set: A
Speaker/load:
Speaker
PTT: OFF
RADIO TUNING AND PROGRAMMING
Tx
Audio Generator
Rx
Sinad Meter
AC Voltmeter
Tx Data
Rx Data
Gnd
Service Monitor
or Counter
Wattmeter
RF Generator
Power Supply
Voltage: 13.8 Vdc (low
power models)
13.6 Vdc (high power
models)
DC on/standby:
Standby
Volt Range: 20 V
Current: 20A