Radio Tuning And Programming; Introduction; Global Radio Tuning Setup - Motorola GP200 Series Service Manual

1.0

Introduction

This chapter provides an overview of the Customer Programming Software (CPS) and tuner program
which are designed for use in a Windows 95/98 environment. These programs are available in
separate kits as listed in the Table 5-1. An Installation instruction manual is also included with each
kit.
Refer to the appropriate program on-line help files for the programming procedures.
NOTE
CPS and TUNER CD
CPS Instructions
TUNER Instructions
2.0

Global Radio Tuning Setup

A personal computer (PC) using Windows 95/98 and a global tuner program are required to tune the
radio. To perform the tuning procedures, the radio must be connected to the PC, radio interface box
(RIB), and test equipment shown in Figure 5-1.
Battery
Eliminator
7.5V Reg.
RLN4510
+12VDC
Power
Supply
Battery Block
0180305G54

RADIO TUNING AND PROGRAMMING

Table 5-1 Software Installation Kits Radio Tuning Setup
Description
RF Adaptor
HLN9756
3.5 mm to
Ferrule BNC
Radio
10 dB Pad
Program / Test Cable
RKN 4074
AC Plug
120/230 Vac
RIB Power Supply
Figure 5-1 Radio Tuning Test Equipment Setup
GMVN4001_
6864113B32_
6864113B31_
T ransmit
Receive
Audio In
Test Box
RLN4460
DB15 DB9
RIB
RLN-4008
Computer Interface
Cable 3080369B72
Chapter 5
Kit Number
Service Monitor
or Counter
Wattmeter
RF Generator
Tx
Audio Generator
Rx
Sinad Meter
AC Voltmeter
Tx Data
Rx
Data
Gnd