Brand Code Search - One for All OARN04S User Manual

During the Auto Code Search, the remote ignores keypresses
that aren't part of the search.
The search times out after two minutes (the POWER key blinks
four times and turns off, and the last programmed code under
that device key is retained).
The POWER key blinks four times and turns off when the
remote has gone through all the codes. The remote exits the
Auto Code Search. If your device hasn't turned off yet, try a
different search method.
Testing the Code for Maximum Functionality
1.
a different code.
2.
3.
remote every 2 seconds until your device turns off again.
4.
programming is complete. If the code stored does not give

Brand Code Search

the select brands listed in the accompanying code list. If your
TIPS: Each device key is associated with a type of device—the
for a different type of device, see the Changing a Key's Device
Type section.
To exit without saving a new code at any point in the Brand
1.
2.
3.
4.
5.
Note: For single-digit brand codes, press the 0 key first (for
example, 0-5 for 5).
4