Miele DG 6010 Operating And Installation Instructions page 75

Problem
After moving house the
appliance no longer
switches from the heat‐
ing-up phase to the
cooking phase.
During operation an un‐
usually large amount of
steam escapes or
steam escapes from
parts of the steam oven
where it does not usual‐
ly.
After a period of time,
the door makes a noise
when it is opened and
closed.
The  symbol appears
in the display and an
audible tone may
sound.
The heating-up phase
lasts an unusually long
time.
Possible cause and remedy
Altitude affects the boiling point of water. If you move
house, the appliance will need to be reset for the new
altitude if this differs from the old one by more than
300 m.
 To adjust the boiling temperature, you need to
descale the appliance (see "Cleaning and care -
Descaling").
The door is not properly closed.
 Close the door.
The door seal is not correctly fitted.
 If necessary, press it in all the way round the door
to make sure it is fitted evenly.
The door seal is damaged, e.g. cracked.
 Replace the door seal. This can be ordered from
Miele.
The door has become stiff.
 Lubricate the hinges with the silicone grease sup‐
plied.
The water container has not been pushed into the ap‐
pliance properly.
 Remove the water container and push it back in
so that it connects.
There is not enough water in the water container. The
water level must be between the two marks.
 Fill the water container
The water container has a lot of limescale built-up in
it because the appliance was not set correctly for the
hardness of the local water supply.
 Set the correct water hardness level for your water
supply (see "Settings).
 Proceed as described in "Cleaning and care -
Descaling".
 If the water hardness level was in fact set correctly
or the problem occurs again, contact Miele.
Problem solving guide
75