Special Funtions - Bosch GV 630 S Repair Instructions

3.2

Special funtions

3.2.1 Settings the hardness range
Hold down the main switch and turn to 9 (one position left) the
program selector. The set value is indicated on the digital display and
the low salt LED flashes. Turning the selector is set the water
hardness value between 0 and 7. If the appliance is switched off, the
value is saved (Table below)
°dH °fH °Clarke
0–3 0–6 0–4
4–6 7–11 5–8
7–9 12–16 9–11
10–12 17–21 12–15
13–16 22–29 16–20
17–21 30–37 21–26
22–30 38–54 27–38
31–50 55–89 39–62
Standard setting = 4
202_58300000104305_ara_en_b – 02.11.a
mmol / l Salt
consumption in
g per rinse cycle
0–0.6 0
0.7–1.1 2
1.2–1.6 4
1.7–2.1 6
2.2–2.9 9
3.0–3.7 14
3.8–5.4 27
5.5–8.9 54
3.2.2 Setting the intensiv drying
Hold down the S2 button and switch on the appliance. 0 is indicated
on the digital display. If the S2 button is pressed again, 1 is displayed
and intensive drying is switched on. If the appliance is switched off,
the value is saved. If intensive drying is activated, the temperature is
increased by 3 K in the final rinse to improve the drying result.
3.2.3 De-activating the rinse-aid refill indicator
Hold down the S1 button and switch on the appliance. 1 is indicated
Set value
on the digital display. If the S1 button is pressed again, 0 is displayed
and the rinse-aid refill indicator is de-activated.
0
1
2
If the appliance is switched off, the setting is saved. If the rinse-aid
3
refill indicator is de-activated, the temperature is increased by 3 K in
4 the final rinse to improve the drying result. (see also
detection)
5
6
7
3.2.4 Program Reset
To reset the program in these models is one position in the program
selector. That means, with the appliance switched on, turn the selector
to the reset position, and in 3 seconds the program is reset.
It pumps during one minute, and reset the module.
I:00 = switched off
I:01 = switched on
3 in 1 detergent
Seite 9 von 53