Hitachi M12V2 Instruction Manual page 10

Refer to pages 4,5,6, before using template
Router Raizer Access Hole
Drill .500" hole
through router
table insert plate
install #30 dust cover insert
into .500" hole and press flush
with top of insert plate
NOTE: This hole must be drilled 1/2" or .500"
for #30 dust cover insert to fit properly.
Use this 6" scale to check accuracy when copied
Note: Cross lines for locating and drilling holes are accurate. The illustration of subbase may vary
slightly in size and design, but is accurate enough for cutting the rubber spacer if required.
Router table fence reference line
Router mounting holes
Additional Templates Available on Website
©
2000-2006 Router Technologies
All Rights Reserved
M12V2
Hitachi
Router Raizer Access Hole
Hitachi M12V2
Page 25
1/2" = .500
.500" reference circle
for drilling table top or
insert plate.