Pptp/L2Tp Settings - D-Link DIR-330 User Manual

Secton 3 - Configuraton
PPTP uses TCP port 1723 for its control connection and uses GRE (IP protocol 47) for the PPP data. PPTP supports
data encryption by using MPPE.
L2TP uses UDP to transport the PPP data. This is often encapsulated in IPSec for encryption instead of using
MPPE.
Enable Settings:
Check this box to enable.
Name:
Enter a name for your VPN.
Connection Type: Select PPTP or L2TP.
VPN Server IP:
Enter the VPN Server IP address which is the
LAN IP of the DIR-330 (I.E. 192.168.0.1).
Remote IP Range:
Assign a range of IP addresses. The assigned
IP range should be on the same network but
not in the same range as your DHCP IP range.
For example, if you network is 192.168.0.xxx
and you set the DHCP range to 192.168.0.100-
200, the remote IP range cannot be within
192.168.0.100-200.
Authentication
Select the desired authentication protocol (PAP/
Protocol:
CHAP/MSCHAP v2).
MPPE Encryption
Select the level of encryption (40-bit/128-bit)
Mode:
Authentication Select Local.
Sources:
User Name:
Enter your username.
Password:
Enter your password.
D-Lnk DIR-330 User Manual

PPTP/L2TP Settings