Connect The Door Arm To The Trolley - Chamberlain 3585CS Owner's Manual

ALL ONE-PIECE DOORS
1. Assemble the door arm, Figure 5:
IMPORTANT: The groove on the straight door arm MUST
face away from the curved door arm.
• Fasten the straight and curved door arm sections
together to the longest possible length (with a 2 or 3
hole overlap).
• With the door closed, connect the straight door arm
section to the door bracket with the 5/16"x1-1/4" clevis
pin.
• Secure with a ring fastener.
2. Adjustment procedures, Figure 6:
• On one-piece doors, before connecting the door arm
to the trolley, the travel limits must be adjusted. Limit
adjustment screws are located on the left side panel
as shown on page 24. Follow adjustment procedures
below.
• Open door adjustment: decrease UP travel limit
- Turn the UP limit adjustment screw counter-clockwise
4 turns.
- Press the door control push button. The trolley will
travel to the fully open position.
- Manually raise the door to the open position (parallel
to the fl oor), and lift the door arm to the trolley. The
arm should touch the trolley just in back of the door
arm connector hole. Refer to the fully open trolley/
door arm positions in the illustration. If the arm does
not extend far enough, adjust the limit further. One full
turn equals 3" (3.75 cm) of trolley travel.
• Closed door adjustment: decrease DOWN travel limit
- Turn the DOWN limit adjustment screw clockwise
4 complete turns.
- Press the door control push button. The trolley will
travel to the fully closed position.
Figure 6
Inner Trolley
Door Arm
Door Arm
Connector Hole
Closed Door
Inner Trolley
Open Door
Outer Trolley
Emergency
Release
Handle
Correct Angle
Figure 5
CORRECT
Straight
Door
Arm
(Groove
facing out)
Door
Bracket
Clevis Pin
5/16"x1-1/4"
- Manually close the door and lift the door arm to the
trolley. The arm should touch the trolley just ahead
of the door arm connector hole. Refer to the fully
closed trolley/door arm positions in the illustration.
If the arm is behind the connector hole, adjust the
limit further. One full turn equals 3" (7.5 cm) of
trolley travel.

3. Connect the door arm to the trolley:

• Close the door and join the curved arm to the
connector hole in the trolley with the remaining
clevis pin. It may be necessary to lift the door
slightly to make the connection.
• Secure with a ring fastener.
• Run the opener through a complete travel cycle. If
the door has a slight "backward" slant in full open
position as shown in the illustration, decrease the
UP limit until the door is parallel to the fl oor.
NOTE: When setting the up limits on the following page,
the door should not have a "backward" slant when fully
open as illustrated below. A slight backward slant will
cause unnecessary bucking and/or jerking operation as
the door is being opened or closed from the fully open
position.
Outer Trolley
Door Arm
Door with Backward Slant
(Incorrect)
23
INCORRECT
Straight
Door
Arm
Curved
Door
Arm
Ring
Lock
Fastener
Washers
5/16"
Straight
Arm
Bolts
5/16"-18x7/8
Curved
Door
Arm
Nuts
5/16"-18
Curved
Door Arm