Trigger In & Out - Russound DMS-3.1 Installation Manual

1. A cable with a 3.5mm mono plug on each end should be connected from the
MCA-C5 #1 12VDC 100mA Trigger Output jack to the
DMS-3.1 Trigger 100mA In jack, indicated by the Green Line.
Connected a DC Multi-meter, positive tip, to the
DMS-3.1 Trigger 100mA Out jack, indicated by the Red Line.
2. The FM Radio Dial should be displayed on the MDK-C5 Keypad indicating the
MCA-C5 is on.
The Multi-meter will measure 12VDC. (10.5VDC – 12VDC is good)
Trigger In & Out
To DC Multi-meter,
Positive Tip
DMS-3.1 Test Procedure
50 of 64