Dispenser - Samsung DMT800 SERIES Service Manual

Part

Dispenser

Reassembly is in the reverse order of the removal.
Photo
3. Disassembly and Reassembly
Description
The dispenser automatically dispenses both the
detergent and the rinse agent at the appropriate times.
The dispenser is activated twice during a wash cycle.
The first time the dispenser is activated (1), the lever
slides up the right-hand path of the connecting rod.
This action moves the cover catch and releases the
detergent cover. When activated for the second time in
a cycle, the lever lifts the connecting rod by the notch,
lifting the rinse dispenser plunger (2) and releasing the
rinse agent.
When close the cover of dispenser, the lever returns to
its original starting position.
The magnetic sensor(3) are connected to rinse aid
lack warning light at control panel by wires. When the
indicator lights up, it should add more rinse aid.
Preparation:
* Disassemble the frame front.
- Refer the "Frame front" disassembly section to
separate the Frame front.
1. Remove the three (3) connectors (blue) on both sides
of the dispenser.
Caution
Right side's rinse aid level sensor connectors are
fasten type. Be careful don't break them when
removing them.
2. Release the six (6) screws (Red) holding at the tub
front and remove the two (2) bracket dispensers in
place.
3. The dispenser is fixed to the tub front with many
hooks. Use several flat screwdrivers to remove it .
4. Push it to the inside carefully.
Caution
Be careful as the tub front is sharp.
3-9