Getting Started - HP J9666A Quick Start Manual

Getting Started

N o t e
Getting Started
You can now connect to the Windows Server 2008 R2 that is running on the
module. You have several options.
You can connect to the module's management port:

a. Connect a management station's Ethernet interface to the manage-
ment port on the front of your module.
b. Configure your management station's Ethernet interface with IP
address, 192.168.2.9, and subnet mask, 255.255.255.252.
c. Establish a remote desktop connection to 192.168.2.10.
d. Log in. Default credentials are:
– Username = SBMAdmin
– Password = P@ssw0rd
Note that in the password, a has been replaced with @ and o has been replaced
with the digit 0.
You can connect to the module through the network.

a. Unless the module belongs in VLAN 1, you must set the correct VLAN
membership for the module's internal port 2:
hostzlswitch(config)# vlan <ID> untagged <slot>2
b. You then have some options:
– Your domain administrator might have created a fixed DHCP
reservation for the module's MAC address. If you know what this
address is, you can establish a remote desktop connection to it
from any management station with network connectivity.
– If you do not know the module's IP address and do not have a
physical connection to it, you can connect to the module CLI
through the HP zl switch CLI. Then you can see the IP address
that the module has been assigned through DHCP, or you can
assign the module a static IP address.
hostzlswitch(config)# services <slot> name hp-svcs-std
hostzlswitch(config)# show ip
If you see a valid address, you can connect to it using RDP.
2
2-1