Integra DTR-30.1 Service Manual page 7

QQ
3 7 63 1515 0
DEBUG MODE-6
HDMI DEBUG MODE-2/2
Input/Output State and Example of FL Display(Continued)
Video Input Format
Source Device
Video resolution is
not Determined
Source Video Format:
PC Format
TE
L 13942296513
NOTE:
1. 1920x1080/24Hz can be displayed in Through Mode only.
2. 640x480p/60 is displaed as "VGA" instead of itself.
Remedy for Error State
Remedy No.
The most possible cause is the hardware trouble of Sink device. Fix it.
1
Refer to HDCP and Authentification error in "DEBUG MODE-7". Follow the procedure.
2
Refer to Resolution error in "DEBUG MODE-7". Follow the procedure.
3
Refer to EDID error in "DEBUG MODE-7". Follow the procedure.
4
Check other HDMI Inputs of AV receiver. If NG, the most possible cause is the hardware trouble of Sink device. Fix it.
5
Check Source device output signal. No signal, or the format is not supported by both HDMI and AV receiver.
6
7 The same as
The most possible cause is the hardware trouble of Sink device. Fix it.
8
The same as
9
The same as
10
www
.
http://www.xiaoyu163.com
FL segment No. --->
Status Description
Video signal route :
HDMI Input ---> Through Mode
Error State ---> Remedy
6
Video signal route : Analog Video Input
---> Up-convert (Via Video Signal Processor)
Error State ---> Remedy 7
Description --->
Source Device PC Video Format : OK,
Sink Device EDID : OK
Normal State
Source Device PC Video Format : OK,
Sink Device Hot plug : Low
Error State ---> Remedy 8
Source Device PC Video Format : OK,
Sink Device HDCP Authenification : Fail
Error State ---> Remedy 9
Source Device PC Video Format : OK,
Sink Device EDID Reading : Error
Error State ---> Remedy 10
VGA input via DVI-HDMI conversion cable
Normal State
VGA input via HDMI cable
Normal State
Remedy
.
6
.
2
.
4
x ao
y
i
http://www.xiaoyu163.com
8
0 1 2 3 4
Input
Horizontal Resolution
Error
Blinks
Q Q
3 6 7 1 3
u163
.
TX-SR607/DTR-30.1
2 9 9 4 2 8
5 6 7 8 9 10
Input
i/p/I/P
Frame Rate
Vertical Resolution
1 5 0 5 8 2 9 9 4
m
co
9 9
11 12 13 14
Error mark
2 8 9 9