Fitting The Harness - Stihl HLA 65 Instruction Manual

1
2
Switch off the machine, move the
N
retaining latch to ƒ and remove the
battery.
Fit the blade scabbard.
N
Pull back the sliding sleeve (1) and
N
use the swivel handle (2) to swing
the joint downwards – in direction of
drive tube – until the cutter bar is flat
against the drive tube.
Release the sliding sleeve (1) and
N
allow lock pin to engage the hole in
the housing.
The sliding sleeve butts against the
housing when the pin is properly
engaged (after making adjustment).
HLA 65

Fitting the Harness

The type of harness is market-specific.
Shoulder strap
2
Put on the shoulder strap (1).
N
Adjust the length of the strap so that
N
the carabiner (2) is about a hand's
width below your right hip.
Attach the machine to the shoulder
strap.
1
2
1
Attach the carabiner (1) to the
N
carrying ring (2) on the drive tube.
Detaching machine from shoulder strap
1
2
Press down the bar on the
N
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
English
2
1
1
2
49