New Buck Corporation 42 Instruction Manual page 26

• If the pilot will not stay lit after several tries, turn the gas control knob to "OFF"
and call your service technician or gas supplier.
THERMO-PILE
THERMO-COUPLE
12. Turn control knob counterclockwise
toggle switch to the "ON" position. The main burner should light.
13. Close access panel door.
14. Turn on all electrical power to the appliance.
NOTE: This unit may be used with an optional Wall Thermostat. If so, the Wall
Thermostat needs to be set at a higher temperature than the room temperature.
SHUTTING OFF UNIT
1. Open access panel door located at bottom front of the appliance.
2. "If equipped with thermostat set to lowest setting."
3. Turn control knob clockwise
4. Turn off all electric power to the appliance if service is to be performed.
5. Close access cover door.
SHUTTING OFF BURNER ONLY (Pilot stays lit.)
Turn control knob clockwise
DO NOT TRY TO ADJUST HEATING LEVELS BY USING THE MANUAL
SHUTOFF VALVE.
IGNITOR ELECTRODE
TO TURN OFF GAS TO
APPLIANCE
to the "OFF" position.
to the "PILOT" position.
CAUTION
PILOT BURNER
to the "ON" position. Push the "ON/OFF"
"REMOVAL OF THIS MARKING WILL
VOID THE COMPLIANCE OF THIS
HEATER WITH ANSI Z21.11.2"
Page 24