Warm Water Connection; Electrical Connection - Siemens SN... Operating Instructions Manual

en Installation and connection
Water pressure:
at least 0.05 MPa (0.5 bar), maximum
1 MPa (10 bar). At a higher water
pressure: connect pressure-reducing
valve ahead.
Inlet rate:
minimum 10 litres/minute
Water temperature:
cold water; hot water max. temperature
60 °C.

Warm water connection *

* depending on model
The dishwasher can be connected
to cold or hot water up to max. 60 °C.
Connection to hot water
is recommended if the hot water can be
supplied by energetically favourable
means and from a suitable installation,
e.g. solar heating system with circulation
line.
This will save energy and time.
The hot water setting :
to adjust your appliance optimally to adjust your appliance optimally to adjust your appliance optimally
to operation with hot water.
It is recommended to have a water It is recommended to have a water It is recommended to have a water
temperature (temperature of the temperature (temperature of the temperature (temperature of the
incoming water) of at least 40 °C incoming water) of at least 40 °C incoming water) of at least 40 °C
and no more than 60 °C. and no more than 60 °C. and no more than 60 °C.
It is not recommended to connect It is not recommended to connect It is not recommended to connect
the appliance to hot water if the water the appliance to hot water if the water the appliance to hot water if the water
is supplied from an electric boiler.
Setting hot water:
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
and press START button h
until : ... is indicated on the digital
display.
4. Release both buttons.
The LED for button # flashes and
the digital display )* displays the
factory setting :
38
Wa r m wa t e r c o n n e c t i o n
allows you allows you allows you
.
5. Press programme button # until
the factory set value :
is indicated on the digital
display )*.
To change the setting:
1. By pressing the 3 button, you can
switch the hot water setting off :
or on : .
2. Press START button h.
The set value is saved.

Electrical connection

Connect the appliance to an Connect the appliance to an Connect the appliance to an
alternating current only, ranging from lternating current only, ranging from lternating current only, ranging from
220 V to 240 V and 50 Hz or 60 Hz 220 V to 240 V and 50 Hz or 60 Hz 220 V to 240 V and 50 Hz or 60 Hz
via a correctly installed socket with via a correctly installed socket with via a correctly installed socket with
protective earth conductor. See protective earth conductor. See protective earth conductor. See
rating plate for required fusing 9:.
rating plate for required fusing rating plate for required fusing
The socket must be near The socket must be near The socket must be near
t the appliance and freely accessible t he appliance and freely accessible he appliance and freely accessible
following installation. following installation. following installation.
If the plug is not freely accessible, an If the plug is not freely accessible, an If the plug is not freely accessible, an
allpole disconnector with a contact
opening of at least 3 mm must be
fitted on the installation side
to satisfy the relevant safety
instructions.
The connection may be modified by
technicians only.
A power cord extension may be
purchased from customer service
only.
Use only a residual current operated
circuit-breaker which features
the symbol ‚. Only this extension
guarantees compliance with
the currently valid regulations.
The appliance features a water
damage protection system. Please
note the system will not function
unless the power supply
is connected.