Adjusting The Height Of The Appliance - AEG FAVORIT 76672 M0P User Manual

22 www.aeg.com
15.1 Adhesive steam
protection
Fit the steam protection on the front part
of the kitchen counter along the entire
width.
15.2 Adjusting the height of
the appliance
1. Remove the adjustable plinth.
2. To adjust the front height of the
appliance, turn the 2 front feet
counterclockwise.
3. To adjust the rear height of the
appliance, turn the middle screw
counterclockwise.
600 mm
15.3 Adjusting the level of the
appliance
A correct adjustment of the level of the
appliance allows the door to close and
seal correctly.
If the door does not close correctly,
loosen or tighten the adjustable feet to
level the appliance.
After adjusting the level of the appliance,
assemble the adjustable plinth on the
appliance.
Once the installation is completed, make
sure that the bottom of the adjustable
plinth is aligned with the floor.
15.4 Installing the appliance
under a kitchen counter or to
adjacent units
The appliance has 6 fixing points:
• 2 external fixing points (2 brackets +
screws)
• 4 internal fixing points (4 spacers +
screws)
Use the 2 external fixing points when
installing the appliance under a kitchen
counter or to adjacent units or if the
opening for the appliance is greater than
600 mm.
Use the 4 internal fixing points if the
opening is 600 mm.
A combination of both fixing methods
can be used if required.
Using the 2 external brackets
This operation must be done before the
appliance is positioned under the
counter.
1. Install the brackets in the slots on the
top of the appliance.