Table of Contents
Advertisement
Capacity
Installation instructions
Installation
Fitting under a counter
WARNING!
Make sure that the mains plug is disconnected from the mains socket during installation.
Put the appliance adjacent to a water tap and a water drain.
Install the appliance under a kitchen counter or work surface.
Make sure that the dimensions of the recess
agree with the given dimensions.
No further openings for the venting of the dish-
washer are necessary, but only to let the water
fill, the drain hose and the power supply cable
pass through.
Make sure that there are no kinks in the water
hoses and that the water hoses are not squashed.
Adjusting the height of the appliance
Do these steps to adjust the height of the appliance:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot. Turn the screw in the middle of the front kick plate to the left or
to the right.
Make sure that the appliance is level to close and seal the door correctly. If the level of the
appliance is correct, the door does not catch on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the adjustable feet until the appliance is level.
Adjusting the height of the plinth
Place settings
23
Installation
12
Advertisement
Table of Contents
