Specifications; General Safety Rules - Makita HR4501C Instruction Manual

ENGLISH
1. Switch trigger
2. Switch lever
3. Adjusting dial
4. Change lever
5. Pointer
6. Lock button

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
Overall length
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............ Read instruction manual.
............. DOUBLE INSULATION
............. Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic equipment and its
implementation in accordance with
national law, electric equipment that have
reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling
facility.
Intended use
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Explanation of general view
7. Power-ON indicator lamp (green)
8. Service indicator lamp (red)
9. Side handle
10. Clamp nut
11. Side grip
12. Bit shank
Model
Carbide-tipped bit
Core bit
-1
)
Net weight
Safety class
HR4501C
7.8 kg

GENERAL SAFETY RULES

END201-2
WARNING! Read all instructions. Failure to follow all
instructions listed below may result in electric shock, fire
and/or serious injury. The term "power tool" in all of the
warnings listed below refers to your mains-operated
(corded) power tool or battery-operated (cordless) power
tool.
SAVE THESE INSTRUCTIONS.
Work area safety
1. Keep work area clean and well lit. Cluttered and
dark areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
ENE044-1
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
ENF002-1
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
13. Bit grease
14. Bit
15. Chuck cover
16. Depth gauge
17. Clamp screw
18. Blow-out bulb
HR4510C
45 mm
125 mm
130 - 280
1,275 – 2,750
458 mm
8.3 kg
/II
HR4511C
8.4 kg
GEA001-3
5