Table of Contents
Advertisement
neath the handle grips.
6. The safety "lock-out" lever (Refer to A on Diagram 1)
is located underneath the right side handle grip and
switch lever. To unlock the "lock-out" lever, use your
right hand fore finger to press the lever down toward
the back of the switch box.
7. With trigger safety interlock in the unlocked position,
Pull up on either side of the ON/OFF lever (Refer to
B on Diagram 1) to power the motor. Pull up on only
one side of the ON/OFF lever.
8. Once the motor is at full speed, carefully lower the
pad onto the floor.
B
A
Diagram 1
TO MANEUVER THE MACHINE
1. Raise the handle slightly and the machine will go to
the right. The higher you raise it, the faster it will go.
2. Lower the handle and the machine will go left. The
more you lower it, the faster it will go.
3. Practice on a smooth surface until you gain experi-
ence in operating the unit.
TO ADJUST THE HANDLE-LOCK
MECHANISM:
1. Unlock the handle and place it in the upright posi-
tion.
2. Tighten the adjusting nut until there is just a slight
drag when the handle is raised or lowered. Do not
overtighten.
3. Place the handle grip into the down (locked) position
to check for proper locking function.
Adjusting nut
TO ADJUST A DRIVE BELT
1. Loosen, but do not remove the 4 bolts, that hold the
motor to the frame.
2. Tighten the 2 screws at the back of the frame until the
B
belt is tight.
3. Test and re-adjust the belt until the belt does not slip.
Re-tighten the four motor bolts.
WARNING: DO NOT OVER-TIGHTEN THE BELT
SERVICING:
In the event that your SATURN requires service, please
contact EDIC:
800-338-3342
No user serviceable components are employed in this
equipment. Do not attempt repairs yourself. EDIC will
assist you in locating an indepedent service contractor.
6
Locking Mechanism
handle
Advertisement
Table of Contents
