Maintenance; Cord Storage And Safety; Cleanup And Storage; Pad Installation - Saturn 20HS1500-SS Owner's/Operator's Manual

MAINTENANCE:

This SATURN has been engineered and built to require
minimum maintenance. But like any machine, it does
require some care to keep it in optimum working condi-
tion. Careful attention to these maintenance instructions
will give you maximum operating performance and life
expectancy of the machine.
CAUTION: Disconnect the power cord from the outlet
before doing any clean up or maintenance on the ma-
chine
1. Keep the machine clean. Do not allow dust to accu-
mulate on external surfaces, the motor, or near any
moving parts.
2. After every job, wipe down the surface of the ma-
chine with a clean damp cloth.
3. Inspect cord for damage. Do not use machine with a
damaged cord.
CORD STORAGE:
While not in use, storage can be accomplished by wind-
ing cord around handle assy. Cord should be
completely unwound during operation.
CORD SAFETY
• Do not leave appliance when plugged in. Unplug
from outlet when not in use and before servicing
• Do not use with damaged cord or plug. If appliance is
not working as it should, has been dropped, damaged,
left outdoors, or dropped into water, return to service
center for inspection and repair.
• Do not pull or carry by cord, use cord as handle,
close a door on cord, or pull cord around sharp
edges or corners. Do not run this SATURN over the
cord. Keep cord away from heated surfaces.
• Do not unplug by pulling cord. To unplug, grasp the
plug, not the cord.
• Do not handle plug or appliance with wet hands.
• Always unplug the machine when removing brush.
• This equipment should be stored indoors and not
exposed to rain.
CLEAN UP & STORAGE
1. Unplug and wrap it under the cord hook and around
the left side handle grip. Clean the cord and inspect it
for cuts, gashes and loose prongs.
2. Wipe down the machine and store in clean dry place.
WARNING:
Do not store the machine with the drive
block, pad driver or brush on the machine.

PAD INSTALLATION:

1. To install pad, tilt the machine back on the rear
wheels until machine is resting on handle.
2. Center the pad on the pad holder and insert pad cen-
ter lock by twisting clockwise. Make sure the center
lock is tight.
To remove: Twist the center lock counterclockwise

MACHINE OPERATION:

This equipment is equipped with a trigger safety inter-
lock. Refer to Diagram 1 for steps 5, 6, and 7.
1. Install the pad driver and pad or attachment.
2. Plug in machine.
3. Adjust the handle to the desired operating position.
4. Lean the machine back, with all four wheels on the
floor, so the pad is not making contact with the floor
when you turn the motor on.
5. Place both hands on the handle grips with your fin-
gers around the on/off lever (Refer to B on Diagram
1) Which extends from one side to the other, under-
5
Center
lock