Table of Contents
Advertisement
ADSL
PPP
2.3 The Rear Ports
PORT
LINE
LAN
RESET
PWR
POWER (Switch)
2.4 Cabling
The most common problem is bad cabling or ADSL line. Make sure that all connected
devices are turned on. On the front of the product is a bank of LEDs. As a first check, verify
that the LAN Link, ADSL , PWR, SYS LEDs are lit. If they are not, verify that you are using
the proper cables.
Ensure that all other devices connected to the same telephone line as your router (e.g.
telephones, fax machines, analog modems) have a line filter (A01-AF2) connected between
• Green for 100Mbps; Orange for 10Mbps
•
Blinking when data transmit/received.
Lights when successfully connected to an ADSL DSLAM.
Steady glow when there is a PPPoA / PPPoE connection.
Connect the supplied RJ-11 cable to this port when
connecting to the ADSL/telephone network.
Connect an UTP Ethernet cable to one of the four LAN ports
when connecting to a PC or an office/home network of
10Mbps or 100Mbps.
Recovery procedures for a lost web interface password:
After turning the router on press the Emergency/Failure
Recovery Button on the back of the modem, and hold the
button in until all lights on the modem flash and it reboots with
factory default settings. The login will be reset to admin and
the password will be reset to atlantis, and the modem will be
accessible via its default IP address at http://192.168.1.254/
This is used when you can not login to the router, e.g. forgot
the password)
Connect the supplied power adapter to this jack.
A Power ON/OFF switch.
WEBSHARE 242W
Meaning
7
Advertisement
Table of Contents
