Makita 5090D Instruction Manual page 5

IMPORTANT SAFETY INSTRUCTIONS
continued
Length of Cord (Feet)
AWG Size of Cord
FOR CORD
25 50 100
150
18 18
18 16
1. To reduce risk of damage to electric plug and cord, pull by plug rather than
by cord when disconnecting charger.
2. Make sure cord
is
located
so
that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
3. An extension cord should not be used unless absolutely necessary.
Use of improper extension cord could result in a risk of fire and electric shock.
If extension cord must be used, make sure that:
i. Pins on plug of extension cord are the same number, size, and shape
as those of plug on charger.
ii. Extension cord is properly wired and in good electrical condition.
iii. Wire size is at least as large as the one specified in the table below.
RECOMMENDED MINIMUM AWG SIZE FOR
EXTENSION CORDS FOR BATTERY CHARGERS
FOR CORD AND CHARGER
1. Do not operate charger with damaged cord or damaged plug
-
replace
them immediately.
SAVE THESE INSTRUCTIONS
5