Bosch GWS 7-115 Operating Instructions Manual page 14

Speed Selection (Type CE)
Material Application
Plastic Polishing
Finish polishing
Metal Finish grinding
Removing paint
Wood, Metal Brushing, Removing rust
Metal, Stone Grinding
Metal Roughing
Stone* Cutting*
* Cutting of stone is permitted only with the cutting guide (optional extra).
Noise/Vibration Information
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 88 dB (A); sound
power level: 101 dB (A).
Wear ear protection!
The typical weighted acceleration is 5.0 m/s
When using the auxiliary handle with vibration
absorption, the hand/arm vibration of the power
tool used is typically less than 2.5 m/s
Intended Use
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
For machines with electronic control: With ap-
proved sanding tools, the machine can be used
for sanding and polishing.
Information Structures
Slots in load carrying walls are subject to the
Standard DIN 1053, Part 1 or country-specific
regulations.
These regulations are to be observed under all
circumstances. Before beginning work, consult
the responsible structural engineer, architects or
the construction supervisor.
1 609 929 C30 • TMS • 15.01.01
Tool
Lamb's wool hood
Felt polishing disk
Buffing disk
Sanding sheet
Cup brush, sanding sheet
Grinding disk
Roughing disk
Cutting disk and cutting guide
2
.
2
.
Dust from light alloys can burn or explode. Al-
ways keep the work place clean, as blends of ma-
terials are particularly dangerous.
English - 2
Thumbwheel
1
1
1
2 – 3
3
4 – 6
6
6
For Your Safety
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety instructions in the
enclosed booklet must be fol-
lowed. Before using for the first
time, ask for a practical demon-
stration.
If the mains cable is damaged or
cut through while working, do not
touch the cable but immediately
pull the mains plug. Never use the
machine with a damaged cable.
Wear protective glasses and ear
protection.
The dust that is produced while
working can be detrimental to
health, inflammable or explosive.
Suitable safety measures are re-
quired.
Examples: Some dusts are re-
garded as carcinogenic. Use suita-
ble dust-/chip extraction and wear a
dust mask.
Wear protective gloves and sturdy
shoes.
When necessary, also wear an
apron.