Table of Contents
Advertisement
Secure the control unit bracket and
side casing with the self-tapping
screws supplied (6 no.).
Locate the back wall casing
with tabs into the notches in the
side casing, and secure with the
self-tapping screws (4 no.) supplied.
Push the control unit housing
with locking tabs into the apertures
on the control unit bracket and pull
forward to its end stop. Secure the
control unit housing with the two
self-tapping screws supplied to the
control unit at the l.h. and r.h. rear,
working from top to bottom.
Route the boiler sensor to the front
and push into the sensor well in
any arrangement, then secure with
the circlip.
14
Boiler assembly
Side casing fixing screws
Rear wall installation
Control unit housing installation
Self-tapping screws
Back wall notches
Self-tapping screws
Control unit bracket
Secure tightly
Locking tabs
3060918_1203
Hide quick links:
Advertisement
Table of Contents
