Hitachi NR 65AK Service Manual page 38

(b) Reassembly
Disassembly procedures should be followed in
the reverse order. Note the following points:
Hang the hook of the Ribbon Spring [85] on
the edge of the Magazine [74] and put the nail
feeder ass'y in the Magazine [74]. Then
secure the nail feeder ass'y with the pin
temporarily (Fig. 36).
Mount the Spring [60] and the Washer [61] to
the Shaft [59] facing the larger winding
diameter side of the Spring [60] to the Washer
[61] (Fig. 37).
Insert the Shaft [59] into the Magazine [74] until the end of the Shaft [59] is shown underneath the Ribbon
Spring [85]. Mount the Washer [61] at the other end of the Shaft [59] to the end surface of the Magazine [74]
(Fig. 38).
Ribbon Spring [85]
Window of the
Magazine [74]
End of the Shaft [59]
Magazine [74]
Pin
Ribbon Spring Hook
Pin
Nail Feeder Ass'y
Washer [61]
Shaft [59]
Larger diameter side of the Spring [60]
Washer [61]
End surface of the Magazine [74]
Fig.38
--- 34 ---
Ribbon Spring [85]
Magazine [74]
Fig.36
Spring [60]
Fig.37