Default Settings And Technical Specifications; Factory Default Settings - NETGEAR WAG102 Reference Manual

Default Settings and Technical Specifications

This appendix provides the factory default settings and technical specifications for the ProSafe
802.11a/g Dual Band Wireless Access Point WAG102.

Factory Default Settings

You can use the reset button located on the front of your device to reset all settings to their factory
defaults. This is called a hard reset.
• To perform a hard reset, push and hold the reset button for approximately 5 seconds (until the
TEST LED blinks rapidly). Your device will return to the factory configuration settings shown
in Table A-1 below.
• Pressing the reset button for a shorter period of time will simply cause your device to reboot.
Table A-1. Access Point Default Configuration Settings
Feature
AP Login
User Login URL
User Name (case sensitive)
Login Password (case sensitive)
Ethernet Connection
Ethernet MAC Address
Port Speed
Local Network (LAN)
Lan IP
Subnet Mask
Gateway Address
DHCP Server
Default Settings and Technical Specifications
Description
192.168.0.232
admin
password
See bottom label.
10/100
192.168.0.232
255.255.255.0
0.0.0.0
Disabled
v2.0, September 2006
Appendix A
A-1