Using The Reset Button To Restore Factory Default Settings - NETGEAR WAG102 Reference Manual
802.11a/g prosafe dual band wireless access point
Hide thumbs
Also See for WAG102:
- Installation manual (2 pages) ,
- Specifications (2 pages) ,
- Reference manual (82 pages)
Table of Contents
Advertisement
ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
Using the Reset Button to Restore Factory Default Settings
The Reset button (see
•
Reboot. When pressed and released quickly, the WAG102 will reboot (restart).
•
Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL
settings to the factory default values.
To clear all data and restore the factory default values:
1. Power off the WAG102 and power it back on.
2. Use something with a small point, such as a pen, to press the Reset button in and hold it in for
at least 5 seconds.
3. Release the Reset button.
The factory default configuration has now been restored, and the WAG102 is ready for use.
5-4
"Rear Panel" on page
v2.0, September 2006
1-8) has two functions:
Troubleshooting
Advertisement
Table of Contents
