NETGEAR WAG102 Reference Manual page 80

ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
• Wireless Point-to-Multi-Point Bridge. Select this only if this WAG102 is the "Master" for a
group of Bridge-mode Wireless Stations. The other Bridge-mode Wireless Stations must be set
to Point-to-Point Bridge mode, using the MAC address of this WAG102. They then send all
traffic to this "Master", rather than communicate directly with each other. WEP can (and
should) be used to protect this traffic.
• Repeater. If selected, this wireless access point will operate as a Repeater only, and send all
traffic to the remote access point. If selected, you must enter the MAC address (physical
address) of the remote access point.
The screens used to configure these options are located by selecting Access Point Settings 11a or
Access Point Settings 11b/g under Advanced on the main menu (see
Figure 4-3
The screens used to configure these wireless access point modes are shown in
and described in the following sections.
4-4
v2.0, September 2006
Figure 4-3 below.
Figure 4-3 above,
Advanced Configuration