Configuring Wep - NETGEAR WAG102 Reference Manual

ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
• To configure WEP encryption for Open Systems or Shared Key, see
on page 2-29.
• To configure WPA with RADIUS, see
• To configure WPA2 with RADIUS, see
page 2-32.
• To configure WPA and WPA2 with RADIUS, see
RADIUS" on page
• To configure WPA-PSK, see
• To configure WPA2-PSK, see
• To configure WPA-PSK and WPA2-PSK, see
on page 2-36.
8. Wireless Client Security Separation is disabled by default. If enabled, the associated
wireless clients will not be able to communicate with each other.
9. Click Apply to save your security profile settings.
10. Click Back. Your new settings will appear in the security profiles table identified by the
Profile Name of the profile. A VLAN ID will also be assigned to your profile.
Note: Security profiles that share the same type of network authentication must share
the same passphrase or keys. Security profiles that use WEP must share the
same four keys, but they do not need to use the same default key.
To enable your security profile:
1. Check the radio box in the Enable column next to your profile.
2. Click Apply. Your security profile will be enabled. If you enabled VLAN 802.1Q, your VLAN
Profile will also be enabled. (See
802.1Q.)

Configuring WEP

To configure WEP data encryption:
1. From the Network Authentication drop-down menu, choose either Open System or Shared
Key authentication.
2. From the Data Encryption drop-down menu, select encryption strength (64 bits, 128 bits, or
152 bits).
Basic Installation and Configuration
"Configuring WPA with RADIUS" on page
"Configuring WPA2 with RADIUS" on
2-33.
"Configuring WPA-PSK" on page
"Configuring WPA2-PSK" on page
"Setting Basic IP Options" on page 2-12
v2.0, September 2006
"Configuring WPA and WPA2 with
2-34.
2-35.
"Configuring WPA-PSK and WPA2-PSK"
"Configuring WEP"
2-31.
to enable VLAN
2-29