Lan Tcp/Ip - NETGEAR RT311 Reference Manual

Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
Table 5-2 lists and describes the fields to use for setting up DHCP parameters..
Table 5-2. DHCP Setup Fields
Field
DHCP Server:
Pool Starting Address
Count
Primary DNS Server
Secondary DNS Server

LAN TCP/IP

Table 5-3 lists and describes the fields to use for setting up TCP/IP parameters for the LAN...
Table 5-3. LAN TCP/IP Setup Fields
Field
TCP/IP Setup:
IP Address
IP Subnet Mask
5-4
Description
If this box is checked, the router acts as a DHCP server.
If this box is cleared, the router's DHCP server is disabled.
The beginning of the range of IP addresses to assign.
The number of sequential addresses available for assignment to
attached hosts. The maximum is 32.
If you want the router to provide the Primary DNS Server address to
attached hosts, enter the DNS address in this field. If this field is 0.0.0.0,
the router assigns its own address as DNS Server, and performs a DNS
Proxy if it can obtain a DNS address from the ISP.
If you want the router to assign the Secondary DNS Server address
to attached hosts, enter the address in this field.
Description
Enter the IP address of the LAN interface of the router in dotted-decimal
notation (four 8-bit numbers, between 0 and 255, separated by periods,
for example, 192.168.0.1). Every device on the TCP/IP network must
have a unique IP address.
An IP address consists of two parts, the network ID and the host ID. The
IP Subnet Mask specifies the network ID portion of the address, written
in dotted-decimal notation. The router automatically calculates this mask
for the class of the IP address that you assign. Unless you have a
special need for subnetting, use the default subnet mask calculated by
the router. All hosts on the LAN segment should use the same mask.
Advanced Configuration of the Router