NETGEAR RT311 Reference Manual page 120

Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
You should see a message like this one:
Pinging <IP address> with 32 bytes of data
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, you could have one of the following problems:
• Wrong physical connections
— Make sure the Local LNK/ACT LED is on. If the LNK/ACT LED is off, follow the
instructions in
— Check that the corresponding Link LEDs are on for your network interface card and
for the hub ports (if any) that are connected to your workstation and router.
• Wrong network configuration
— Verify that the Ethernet card driver software and TCP/IP software are both installed
and configured on your PC or workstation.
— Verify that the IP address for your router and your workstation are correct and that the
addresses are on the same subnet.
11-6
"LNK/ACT LEDs Not On" on page 11-2.
Troubleshooting