Troubleshooting; Basic Functioning; Power Light Not On - NETGEAR RP614 v4 Reference Manual

Netgear cable/dsl router reference manual

Hide thumbs Also See for RP614 v4:

Declaration of conformity (4 pages)

Introduction (4 pages)

Table Of Contents

Table of Contents

This chapter gives information about troubleshooting your RP614v4 Cable/DSL Router. After

each problem description, instructions are provided to help you diagnose and solve the problem.

Basic Functioning

After you turn on power to the router, the following sequence of events should occur:

1. When power is first applied, verify that the Power light

2. After approximately 10 seconds, verify that:

a. The power light is solid green.

b. The LAN port lights are lit for any local ports that are connected.

c. The Internet port light is lit.

If a port's light is lit, a link has been established to the connected device. If a LAN port is

connected to a 100 Mbps device, verify that the port's light is green. If the port is 10 Mbps, the

light will be amber.

If any of these conditions does not occur, refer to the appropriate following section.

Power Light Not On

If the Power and other lights are off when your router is turned on:

•

Make sure that the power cord is properly connected to your router and that the power supply

adapter is properly connected to a functioning power outlet.

•

Check that you are using the 5 V DC 1A power adapter supplied by NETGEAR for this

product.

If the error persists, you have a hardware problem and should contact technical support.

v3.1, June 2008

Chapter 5