Using The Router As A Dhcp Server - NETGEAR RANGEMAX WNR3500 User Manual

Wireless-n gigabit router
Hide thumbs Also See for RANGEMAX WNR3500:
Table of Contents

Advertisement

NETGEAR RangeMax™ Wireless-N Gigabit Router WNR3500 User Manual
The LAN IP settings are:
IP Address. The LAN IP address of the router.
IP Subnet Mask. The LAN subnet mask of the router. Combined with the IP address, the IP
subnet mask allows a device to know which other addresses are local to it, and which must be
reached through a gateway or router.
RIP Direction. RIP allows a router to exchange routing information with other routers. The
RIP Direction selection controls how the router sends and receives RIP packets. Both is the
default.
When set to Both or Out Only, the router broadcasts its routing table periodically.
When set to Both or In Only, the router incorporates the RIP information that it receives.
When set to None, the router does not send any RIP packets and ignores any RIP packets
received.
RIP Version. This controls the format and the broadcasting method of the RIP packets sent by
the router. (It recognizes both formats when receiving.) The default setting is RIP-1.
RIP-1 is universally supported. RIP-1 is usually adequate unless you have an unusual
network setup.
RIP-2B carries more information than RIP-1 and uses subnet broadcasting.
RIP-2M carries more information than RIP-1 and uses multicasting.
Note: If you change the LAN IP address of the router while connected through the
browser, you will be disconnected. You must then open a new connection to the
new IP address and log in again.

Using the Router as a DHCP Server

By default, the router functions as a DHCP server, allowing it to assign IP, DNS server, and default
gateway addresses to all computers connected to the router's LAN. The assigned default gateway
address is the LAN address of the router. The router assigns IP addresses to the attached computers
from a pool of addresses specified in this screen. Each pool address is tested before it is assigned to
avoid duplicate addresses on the LAN.
For most applications, the default DHCP and TCP/IP settings of the router are satisfactory. Click
the link to the online document
DHCP and information about how to assign IP addresses for your network.
Customizing Your Network Settings
"TCP/IP Networking Basics" in Appendix B
v1.0, March 2008
for an explanation of
4-3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents