Denon AVR-1712 Owner's Manual page 69

Setting items
GUI Screensaver : Make screensaver settings.
Make the settings related to • ON : The screensaver is activated during menu
displays on the TV screen. display, iPod or TUNER screen display if no
operation is performed for an approximately
5-minute continuous period. When you press
uio p
, the screensaver is cancelled and
the screen before that screen saver started is
displayed.
• OFF : Screensaver is not activated.
Format : Set the video signal format to be output for the TV you are using.
• NTSC : Select NTSC output.
• PAL : Select PAL output.
"Format" can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit's 2 and 9 for at least 3 seconds.
"V.Format:<NTSC>" appears on the display.
2. Press the main unit's
format.
3. Press the main unit's
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Text : Display the details of operation when switching surround mode,
input mode, etc.
• ON : Turn display on.
• OFF : Turn display off.
Master Volume : Display the master volume during adjustment.
• Bottom : Display at the bottom.
• Top : Display at the top.
• OFF : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to "Top".
iPod : Set the iPod screen display time when the input source is "DOCK".
• Always : Show display continuously.
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
BD
Setting details
TUNER PRESET CH +, –
and set the video signal
iPod
1 to complete the setting.
Setting items
GUI Tuner : Set the tuner screen display time when the input source is
(Continued) "Tuner".
• Always : Show display continuously.
• 30s : Show display for 30 seconds after operation.
• 10s : Show display for 10 seconds after operation.
• OFF : Turn display off.
Remote Setup Guide See "Registering preset codes" (vpage 75).
Search a preset code to
register in the remote
control unit.
Quick Sel.Name • Up to 16 characters can be input.
Change the "Quick Select" • For character input, see page 50.
display title to one you
prefer.
Zone Rename • Up to 10 characters can be input.
Change the display title of • For character input, see page 50.
each zone to one you prefer.
Bright : Normal display brightness.
Dimmer
Adjust the display Dim : Reduced display brightness.
brightness of this unit. Dark : Very low display brightness.
OFF : Turns the display off.
Buttons on the main unit can be used for operations.
Each time
below.
Setup Lock ON : Turn protection on.
Protect settings from OFF : Turn protection off.
inadvertent change.
When canceling the setting, set "Setup Lock" to "OFF".
NOTE
When "Setup Lock" is set to "ON", the settings listed below can no
longer be changed. Also, "Setup Lock!" is displayed if you attempt to
operate related settings.
• Menu operations
66
System Setup
Setting details
DIMMER
is pressed, the setting is changed as shown
Bright Dim
OFF Dark
• Channel Level