Table of Contents
Advertisement
AXIS Q1775-E Network Camera
Hardware Overview
LED Indicators
Note
• The Status LED can be configured to be unlit during normal operation. To configure, go to Setup > System Options > Ports
& Devices > LED. See the online help for more information.
• The Status LED can be configured to flash while an event is active.
• The Status LED can be configured to flash for identifying the unit. Go to Setup > System Options > Maintenance .
Status LED
Green
Amber
Note
The Network LED can be disabled so that it does not flash when there is network traffic. To configure, go to Setup > System
Options > Ports & Devices > LED. See the online help for more information.
Network LED
Green
Amber
Unlit
Note
The Power LED can be configured to be unlit during normal operation. To configure, go to Setup > System Options > Ports &
Devices > LED. See the online help for more information.
Power LED
Green
Amber
Status LED Behavior and Buzzer Signal for Levelling Assistant
For information on using the control button to start levelling of the camera, see page 9 .
Color
Fixed green
Flashing green
Flashing orange
Flashing red
Indication
Steady green for normal operation.
Steady during startup and when restoring settings.
Indication
Steady for connection to a 100 Mbit/s network. Flashes for network activity.
Steady for connection to a 10 Mbit/s network. Flashes for network activity.
No network connection.
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
Buzzer
Continuous beep
Fast interval
Medium interval
Slow interval
Camera position
Level
Almost level
Not level
Far from level
10
Advertisement
Table of Contents
