HP HPE StoreOnce 3100 Series Maintenance And Service Manual page 46

1. Power off the HPE StoreOnce System and, observing the safety and antistatic procedures,
remove all external cabling to the PCIe cards and remove the cover from the HPE StoreOnce
System, as described in the appropriate HPE ProLiant Maintenance and Service Guide.
The HPE StoreOnce 3500 Series and HPE StoreOnce 5100 System may have a PCIe
10GbE Network or Fibre Channel card in slot 1.
The HPE StoreOnce 5100 System may be connected to external SAS storage.
2. Remove the PCIe riser cage (for slots 1 to 3) and locate the p1224 controller card in slot 3..
Detach the cables connecting the p1224 card to the SuperCapacitor, and the SAS storage.
3. As shown in the following figure, unclip the blue retaining latch on the PCIe card (1 and 2)
and remove the PCIe card (3).
Figure 23 Removing a p1224 card
4. Install the new p1224 card (1) and check that it is seated properly. Close the blue PCIe card
retaining latch (2).
Figure 24 Inserting a p1224 card
5. Reconnect all internal SAS cables. See
for internal SAS cabling.
IMPORTANT:
have a PCIe 10GbE Network or Fibre Channel card in slot 1. Verify that this card has not
been dislodged.
6. Replace the PCIe riser cage and the server cover, as described in the appropriate HP
ProLiant Maintenance and Service guide.
7. Reconnect all external cables.
8. Power on the HPE StoreOnce System
9. Once rebooted, the HPE StoreOnceSystem will identify the new RAID controller and will
remap the existing disk storage volumes and enclosures to the controller. It will take 5 to 10
minutes for the process to complete. During this time the product will be online but several
46 Replacing the p1224 RAID controller and components
3
The HPE StoreOnce 3500 Series and HPE StoreOnce 5100 System may
1
2
Internal SAS cabling (page 41) and the hood label