Setting Up Wep Encryption Security - NETGEAR WG111T User Manual

NETGEAR 108 Mpbs Wireless USB 2.0 Adapter WG111T User Manual

Setting up WEP Encryption Security

Follow the steps below to configure WEP Encryption Security.
1. Run the WG111T Smart Wizard.
a. Make sure the WG111T software is installed and the WG111T is connected to the USB
port in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab page opens.
Figure 2-9
2. Configure the Security settings.
a. In the Profile box, select the profile or type in a profile name.
b. In the Network Name (SSID) field select the network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
matches exactly what is configured in the access point.
c. In the Security section, select WEP.
3. Select the WEP encryption strength you will use:
• 64-bit WEP data encryption
• 128-bit WEP data encryption
2-12
v2.0, February 2007